B150708 Base station communication error
Check communication settings, cable and station number. The driver received an unexpected response. Verify that the devices exist and that their addresses are within a valid range for the connected controller. . When troubleshooting the Base Station with a Cordex power supply on site, you may need to connect to the Cordex power supply to obtain further information and resolve issues. I have checked all parameters, addresses and stations from the comms side countless amount of times, however I am still getting a write error communication error 7 (Incorrect address) on. . This section describes some possible station setup and static measurement issues, possible causes, and how to solve them. DwPTS OTA Power when added. . The error message is shown on the display of the HMI. [PDF Version]FAQS about B150708 Base station communication error
Why is my base station not broadcasting?
The software sets up all radio and receiver operating parameters, and is the most likely route to a successful problem resolution once you have checked all connections, cables, and batteries. The base station is not broadcasting. See Base station is not broadcasting below. Incorrect over-the-air baud rates between base station and rover.
How do I know if a base station is not tracking?
You check SteamVR and see that one of the base stations is not tracking. You peek at a base station and see a blinking red light. OH NO! If you still have the base station under warranty, no need to panic, this can happen, you just contact Valve/HTC support (depending where you bought it from) and they will offer you a replacement.
Why is my scs900 radio not receiving data?
If the radio is receiving data (the Radio LED is flashing) and the receiver is not receiving data, check the port settings of the receiver and radio using the Siteworks or SCS900 Site Controller software; match the settings and try again. The radio antenna cable and GPS antenna cable are mixed up.
How do I fix a bad baud rate between base station and Rover?
Incorrect over-the-air baud rates between base station and rover. Connect to the roving receiver's radio and make sure that it has the same setting as the base station receiver. Mismatched channel or network number selection. Match the base station and rover radio channels/network number and try again.